SUSPENSION - Terminology

Glossary of terms used in the suspension on the mini. The Mini has consistently more than proven its capability in competition with very limited and cost-effective modifications based on the standard equipment fitted. Having first ensured the bodyshell (in reality little more than a complex bracket to hold suspension and driver securely in place) is well sorted out by removing all cruddy or rotten metalwork and into something like straight, square and strong we, maximising suspension stability and geometry pays dividends in the enjoyment that is driving a Mini. Understanding what the individual ingredients are helps in pursuing what you want from the experience. Smooth Mover Good, reliable, and consistent handling is dependent on a number of factors. At this stage, we’re concerned with clapped out or badly adjusted suspension components. Stiff, seized, partially seized or slack, sloppy, worn out suspension components will cause inconsistent, wayward, confusing and – more important

Brakes - Fitting Discs and Required Ancillaries

What you actually need for the disc/drum conversion is pretty straightforward. Disconnect the steering arms, top and bottom swivel-pins, CV joint, and flexible brake pipes at the subframe - that’s it. There are, however, a number of ancillaries to consider.

Basics

Basics Fitting discs designed for the Mini is easy enough. Just make sure you use CV gaiters for the disc-brake set-up - these have a different bellows shape to stop the gaiter rubbing the inside of the hub. The drum type will rub, then split, shedding grease all over the place. Moly grease is mighty mucky stuff to deal with and doesn't assist braking at all! A tip for racers - to stop the gaiters over-expanding when getting very hot and imitating the aforementioned, put either a decent sized split pin or (my favorite) a piece of very small bore pipe - as in the type supplied with WD40 aerosols, etc. - under the retaining strap on the drive shaft. This allows air to escape and return,

Brakes - Fundamental Considerations

When looking to increase their cars performance, most folks immediately turn to considering higher engine power outputs. Because of this pre-occupation brakes tend to slide down the improvements priority list. However, they are far more important - being able to accelerate at warp speed to hyper-space in the twinkling of an eye is all very well, but disastrous if you can’t stop. You will make a very big hole in the scenery, and possibly end up wearing an wooden over-coat. Getting the braking system sorted out can help to make the car quicker, as you will be able to more confidently, therefore maximising speed in any given situation. Being one of those ‘sciences’ used in the automotive industry I hope to shed some light on the subject as it's another of those where many questions from confused and mislead folks that clog up my e-mail board. The advent of the Metro, and the brakes used on it has spawned a lot of activity in this direction. It was soon discovered that they could b

C-AJJ4064 – 8 PORT CYLINDER HEAD

The combustion chambers are left in a basic shape only with a nominal 16.4cc which allows enough metal for those with the latest advanced ideas of shape to apply them and create the correct compression ratios for the desired use.

Valve and seat material specification allows use of unleaded fuel. Thoroughly clean the cylinder head before final assembly. Check that the small circlip is in the correct position in the valve guide at a point where the guide protrudes through the cylinder head beneath the valve seat. Place the valve spring seat over...

Historical Article - October 1993 - Converting WET to DRY suspension

Converting WET to DRY suspension The following is a practical way of converting your wet suspension to dry, acknowledging the fact that with enough skill, enterprise and facilities...